What did you do for your Volkswagen today?

[Roadhog]

should install a k&N.

[Darkside]

Replaced accessory belt and tensioner. old tensioner isn't as bad as I thought< nice and quite now anyway

[YASHA7FOLD]

Pulled the exhaust manifold and turbo also the oil lines. Tomorrow I will be getting the new gaskets from 034 and reassembly will begin.

[Darkside]

Pulled the exhaust manifold and turbo also the oil lines. Tomorrow I will be getting the new gaskets from 034 and reassembly will begin.

Nice, you should grab those parts from me and you can start customizing the bumper rebar

[YASHA7FOLD]

There was one manifold nut that was rounded off so I am still working on that, one of the turbo inlet bolts broke off inside the housing( I hope I can get it with an easy out ), and the manifold is cracked. What a day.

[AKRadar]

Managed to replace the sway bar bushings.. And strip the last "&"&$@"@@@ bolt of the project.. But so far the lock tight is holding.. Now for the120k maintence. Anyone have suggestions as what to check along with replacing plugs and wires?

[Mrbubblehead]

Hammered away with the rewiring of the bug(not done). If you cant drag the dome light off the original wiring, you end up cursing a lot, throwing stuff, and spending too much time doing something that should take a minute. I got that wiring drug, I'm not sure where it came out of because I cant see it, but i got it done. I know for sure it is a tiny hole somewhere behind the hood hinge, hood spring, and defroster ducting.

[Mikewire]

Attempted to pull the upper intake manifold. How in the #$%$#% do you get to the x4 6mm hex bolts with 1" of room between the runners and the radiator??? I started making custom tools, and even those wouldn't fit.

[Roadhog]

Attempted to pull the upper intake manifold. How in the #$%$#% do you get to the x4 6mm hex bolts with 1" of room between the runners and the radiator??? I started making custom tools, and even those wouldn't fit.

Jack the motor up...

[Mikewire]

This, I will try.