Page 4 of 7
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Fri 01, 2009 9:54 am
by CBCGSXR1000
sounds good to me

Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Fri 01, 2009 11:03 am
by Darkside
a guy in Billings owns a dyno as well. Only 2 wheel drive though. I was thinking of doing a dyno day here in town. Either one would be fun

Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Fri 01, 2009 2:01 pm
by JayRyan
Darkside wrote:a guy in Billings owns a dyno as well. Only 2 wheel drive though. I was thinking of doing a dyno day here in town. Either one would be fun


Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Fri 01, 2009 3:04 pm
by Mikewire
JayRyan wrote: 
x2
While you guys are strapping your cars down, JR and I will go drive.
J/K it would be cool to watch, and see the results.
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Fri 01, 2009 4:10 pm
by Darkside
MikeWire wrote:JayRyan wrote: 
x2
While you guys are strapping your cars down, JR and I will go drive.
J/K it would be cool to watch, and see the results.
The awd guys speak

I thought you would like that.
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: May Mon 11, 2009 9:39 pm
by CBCGSXR1000
That would be cool with me.
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: Jun Sun 28, 2009 8:57 am
by CBCGSXR1000
i took my exhaust manifold off.
now when i put it back on cant get turbo n manifold to seal.
tryed to put stock one back on still wont seal.
any ideas its pissin me off
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: Jun Sun 28, 2009 9:31 pm
by Mikewire
maybe get some support under the exhaust or unbolt the turbo from the downpipe and see it sits flush?
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: Jun Mon 29, 2009 1:41 pm
by CBCGSXR1000
i got them machiend just to be safe.
so they do fit also tryed to to stock one back on same leak.
unbolted turbo from down pipe and jacked exhaust up still leaks
im not sure wat else to do
Re: Going Beyond Bolt-ons: The CBCGSXR1000 story
Posted: Aug Sun 16, 2009 9:16 am
by CBCGSXR1000
so got that leak fixed but needed thick gasket between engin n manifold
should be done soon i hope