Automatic To Manual Transmission swap project.

Post by **kompressorgolf** » Aug Mon 20, 2007 12:12 pm

we see it drive then you have a stickshift

Post by **Roadhog** » Aug Mon 20, 2007 12:31 pm

kompressorgolf wrote:we see it drive then you have a stickshift

can I push it down a hill then hop in?

Post by **kompressorgolf** » Aug Mon 20, 2007 3:30 pm

Post by **Roadhog** » Aug Fri 24, 2007 5:14 pm

Redoing all my axle boots.. Cleaning the CV joints and repacking them with synthetic grease. What a mess.

Post by **Roadhog** » Aug Tue 28, 2007 5:38 pm

BAM! All clean and shiny...

Post by **CBCGSXR1000** » Aug Tue 28, 2007 7:09 pm

Ya it looks like fun.Is that ur moms hammer

Post by **Roadhog** » Sep Fri 07, 2007 9:50 pm

Tehehe.. IT HAS RUNNETH!!! It runs, drives, all that good shi. Even check engine lights! Its 110% VW.

Check engine light is for the oxygen sensor. I think I just fucked it up putting the water pump in. lol.

But damn, it feels good to hop in and go for a rip around the neighborhood in a Corrado with no exhaust past the cat. Sounds like a stock car.

Post by **Mill3niumThr33** » Sep Sat 08, 2007 1:15 am

Roadhog wrote: But damn, it feels good to hop in and go for a rip around the neighborhood in a Corrado with no exhaust past the cat. Sounds like a stock car.

Welcome to my everyday life...haha i run just off of the cat and a 90 degree bend out the side

Post by **I B GOLFIN** » Sep Sun 09, 2007 2:09 pm

Got a question. Do any of you guys know what each pin on a digi 1 computer are for. im havin a lil trouble converting my car from a cali digi to a regular digi1. a good site for wiring diagrams would be great. Damn i hate wiring

Post by **I B GOLFIN** » Sep Sun 09, 2007 10:58 pm

never mind that last post i did some searchin and found out every thing i need to know. thx