Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 2:41 pm
I would pick up a bunch of aircraft stripper and go to town. Much easier than a wire wheel, and WD-40 won't do anything to paint.
oh and pics Big Sky Euro
An online community for VW/Audi and other Euro Enthusiasts
http://bigskyeuro.com/forums/
Jd3 ninja 16v
Page 6 of 17
Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 3:33 pm
from experiene, a conical braided wire wheel on a grinder is the best method, and other than alot of dust, the cleanest. just wear a SARS mask oh and pics
oh and pics Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 9:31 pm
yep... im rockin a braided wheel on a grinder and a drill with 7 different wire brushes to get those hard to reach spots. thats what really slows the process down.. slow and steady.. So she s flipped!!! should get it completed tomorrow. 
Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 9:58 pm
Prep Master
Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 10:04 pm
Thanks let me know when you are done with it.
Re: Jd3 ninja 16v
Posted: Jan Tue 04, 2011 10:24 pm
ill show you going to town with some strippersMikeWire wrote:I would pick up a bunch of aircraft stripper and go to town. Much easier than a wire wheel, and WD-40 won't do anything to paint.
Re: Jd3 ninja 16v
Posted: Jan Wed 05, 2011 12:57 pm
Thanks for the pics!
Re: Jd3 ninja 16v
Posted: Jan Wed 05, 2011 7:33 pm
well here s some more big trev and everyone... I m very bad about taking pics... when i get workin I just keep going and going until things are done...
Re: Jd3 ninja 16v
Posted: Jan Wed 05, 2011 7:37 pm
this seriously was one of the most tedious things ive done in awhile ( I would say about 20 hours of non stop hustle )... kinda nerve racking too. but hopefully it pays off.
Re: Jd3 ninja 16v
Posted: Jan Wed 05, 2011 7:56 pm
Doin' it right.