FS: Mega Squirt v 2.2 ecu with launch control & map switch
Posted: Aug Mon 22, 2011 12:48 pm
Got this MS setup a few years ago and no longer have room for it in the shop. Has some interesting stuff on it, including the launch control and map switching. I am not sure who built the board, not myself though. It has been looked at by needavr6 and deemed worthy. Here are the pinouts.
Pin 4 - Launch Input - ground to trigger
> Pin 8 - Table Switching Input - ground to trigger
> Pin 24 - Hall Sensor Signal
> Pin 25 - Output 1
> Pin 27 - Output 4
> Pin 29 - Output 2
> Pin 31 - Jumpered to X7 - looks like it's for a MAF input
> Pin 36 - Spark Output
>
> This one will have hall power off of TPS power on Pin 26. It will take
> a bit of setting tinkering to get everything to work but all the
> hardware is there for the above.
the led lights are not present because they are used for additional outputs, i believe one is for a fan switch. the audi connectors and some new pins are included to make it look nice and factory.
looking for $350 obo
Pin 4 - Launch Input - ground to trigger
> Pin 8 - Table Switching Input - ground to trigger
> Pin 24 - Hall Sensor Signal
> Pin 25 - Output 1
> Pin 27 - Output 4
> Pin 29 - Output 2
> Pin 31 - Jumpered to X7 - looks like it's for a MAF input
> Pin 36 - Spark Output
>
> This one will have hall power off of TPS power on Pin 26. It will take
> a bit of setting tinkering to get everything to work but all the
> hardware is there for the above.
the led lights are not present because they are used for additional outputs, i believe one is for a fan switch. the audi connectors and some new pins are included to make it look nice and factory.
looking for $350 obo