what is the easiest way???>

Post by **kompressorgolf** » Feb Mon 19, 2007 2:31 pm

what is the easiest way to get all that crap off the floor of rabbits, the insulation stuff under the carpet padding, i hope its not a puddy knife ive been doin that for hours, with little results, all that glue too

Post by **Ramrod** » Feb Mon 19, 2007 2:38 pm

Just a shot in the dark, but how about a grinder with a brush wheel, a mask, and a shop vac?

Post by **PoorHouse** » Feb Mon 19, 2007 3:04 pm

I used a heat gun to warm it up a little then a putty knife. Came off real easy. Cleaned up the remaining stuff with a wire wheel.

Also heard dry ice and a hammer work well.

Post by **ValveFloat** » Feb Mon 19, 2007 4:27 pm

I have also heard that dry ice makes that job easy. The way it was explained you lay pieces of the ice on the stuff and gets super brittle so its easy to scrape off.
A fellow autocrosser did this to his CRX and the results were impressive.

Post by **Custom VW** » Feb Wed 21, 2007 12:24 pm

wish I would have remembered that trick...

I ended up buying a rubber wheel for the grinder. dry-ice is frickin cheap

Post by **Rennwagen1** » Feb Wed 21, 2007 1:11 pm

Custom VW wrote: dry-ice is frickin cheap

And fun at Halloween parties!